Settings for USB Device Router:
Audio tab:
Follow radio is recommended.
If Router does not support your radio use the Fixed settings appropriate to your primary operating mode.
PTT/FSK tab:
Follow radio is recommended.
If Router does not support your radio use the Fixed settings appropriate to your primary operating mode.
To create a Preset for ACLog, click on Menu | Preset | Save As.
Settings for ACLog 2.9:
Radio Setup
 |
|
The Comm port should be same as was assigned for Control in Router. Baud rate is determined by the radio requirements. Connection Power should be "none" PTT will be set in the Voice on RTTY mode setup |
CW & WinKey Setup
 |
 |
| To configure CW in ACLog 2.9, Select Settings | Transmit | CW Settings. In the Keying Options Setting select WinKey and click on "Configure WinKey." On the WinKey Setup screen Select Com Port to match the one chosen for WinKey in Router Pin 5 Configuration should be PTT or "P5 off P3 Key Out." All other settings are "operator preference." |
|
PTT and DVK Configuration
 |
|
You may use PTT for DVK operation or K7SE RTTY but not both To set up PTT with DVK, Select Settings | Transmit | Phone Set Up Select RTS and the Port chosen for PTT in Router |
Configuring K7RE RTTY for FSK
 |
|
 |
K7RE FSK Uses the MMTTY
engine. First select a PTT and FSK Port by opening Setup | Setup Engine | New Engine Setup and selecting the PTT port on the TX tab. The port chosen should match the FSK and PTT To use FSK in MMTTY select either: Sound + COM-TxD (FSK) -or- COM-TXD (FSK) on the Misc tab in the MMTTY configuration. Then click the "USB Port" button and select "C: Limiting speed" as the Processing method. |